Hi, What is car.ini steering rod ratio all about? is it converting controller input to car input?
Also, Where is the SteringRatio values in the suspension dev app (pictured below) , I think it is the box that says [STR: ***]
If I turn my wheel 90 degrees should I see 90 in here?
Finally, what is KPI? I know caster and scrub angle, but I am not familiar with this one?
[
LINEAR_STEER_ROD_RATIO=0.00175 ; Because of AC complex suspension geometry, you need to calculate manually the steer rod ratio
; Enter AC in dev app mode enabled
; Open SUSPENSIONS app
; turn your steering wheel by 90 degrees
; check the actual steer ratio value
; modify LINEAR_STEER_ROD_RATIO value until ingame steer ratio and car.ini STEER_RATIO values are similar
Also, Where is the SteringRatio values in the suspension dev app (pictured below) , I think it is the box that says [STR: ***]
If I turn my wheel 90 degrees should I see 90 in here?
Finally, what is KPI? I know caster and scrub angle, but I am not familiar with this one?
[
LINEAR_STEER_ROD_RATIO=0.00175 ; Because of AC complex suspension geometry, you need to calculate manually the steer rod ratio
; Enter AC in dev app mode enabled
; Open SUSPENSIONS app
; turn your steering wheel by 90 degrees
; check the actual steer ratio value
; modify LINEAR_STEER_ROD_RATIO value until ingame steer ratio and car.ini STEER_RATIO values are similar
