PROBLEMS WITH FLAG

[quetillo]

Hello people, I have a problem or doubt, however you want to say it, I made some vertical flags in blender, I configured them in blender so that they would work in AC. So far so good, I tried exporting just one, the same flag has a texture as seen in the photo, so I just have to change the UV to have the same flag with a different logo, the problem is that if I duplicate one as seen in the image, in kseditor I configure it fine, but then in AC it comes out like this, what could it be. Thank you

 

[Johnr777]

Show UV

 

[quetillo]

I did the UV one by one, with the corresponding modification and now they work for me, but the problem is that some move more than others with the same configuration, but hey, at least I think I know how it goes.

 

[Johnr777]

The flag moves vertices from left to right, so your texture and UV mapping is not compatible. Stack them vertically

 

[quetillo]

The flag moves vertices from left to right, so your texture and UV mapping is not compatible. Stack them vertically

Thank you, the attachment of this flag is vertical. I didn't understand the explanation. I first create the UV, then select vertices on the side of the stick, then duplicate and separate a little, the UV on the opposite side, I rotate it horizontally and put them together, to have a layer with 2 UV